Acrylic Diamond Shield 50 Cure and Seal - 5gal

The Concrete Protector's Acrylic Diamond Shield 50 is an exterior concentrated styrene copolymer in a solvent base sealer. Dries by solvent evaporation to a tough protective film with excellent resistance to UV light, water, and a wide variety of chemicals. Designed for use as a cure and seal for new concrete or as a seal coat for decorative concrete coatings. Must be mixed 1:1 with DMC or Xylene before application. Apply two thin coats for best results.

Specifications:

• Size: 5 Gallon
• Color: Clear
• Mix Ratio: 1:1 with DMC or Xylene (DO NOT USE WITHOUT THINNING)
• Coverage: Old Concrete 330-400 sq. ft./gal, New Concrete 220-350 sq. ft./gal
• 1st Coat: 130-150+ sq. ft./gal
• 2nd Coat: 190-210+ sq. ft./gal
• Dry to Touch: Less than 1 hour (longer on cooler days in shade)
• Light Foot Traffic: 2-5 hours
• Full Cure: 28 days
• VOC: <300 g/l
• Shelf Life: Up to 2 years in unopened containers

Key Benefits:

• Excellent UV light resistance
• Excellent water resistance
• Resistant to a wide variety of chemicals
• Dries to a tough protective film
• For exterior use

Recommended Applications:

• Cure and seal for new concrete
• Seal coat for decorative concrete coatings
• Use over Texture Mix or Stamp Mix

Chemical Resistance:

• Motor Oil: No change
• Sodium Hydroxide: No change
• Sulfuric Acid: No change
• Gasoline: Softened
• Acetic Acid: Blistering
• Hydrochloric Acid: Loss of gloss
• Nitric Acid: Slight blistering

How to Use:

1. Mix 1:1 with DMC or Xylene (if approved by your state). Mix thoroughly with drill and wand. DO NOT USE WITHOUT THINNING
2. Dip and roll two thin coats over Texture Mix or Stamp Mix with a 3/4" nap jumbo roller cover and frame
3. Use anti-slip additive in final coat to prevent slip and fall
4. Cleanup with Xylene

Limitations:

• Restrict floor use to light traffic and non-harsh chemicals until fully cured
• Keep floor dry for full cure cycle
• Some cleaners may affect floor color - test in small area first